How do I remove the PCIE brackets at the back of a case?

[Mocharok]

Hiya everyone.

I'm receiving my new GPU tomorrow and the backing requires two slots. Unfortunately, this case has only one open and I did not set it up initially.

I have a picture included; how do I remove this little thing so my GPU has enough slots open? Thanks in advance!

note: I've tried moving it a bit, but I'm just not sure if I'm supposed to "tear" it off so to speak, or what. So yes, any help would be appreciated 😀

 

[smorizio]

push it in slowly..then back out till it snaps off. watch out it have a sharp edge so dont cut yourself...also break the one you need. on cases like the one you have once it snapped off you have to use a filler plate that has a screw on it.

 

[Cons29]

try to look closer, there should be (depending on the case) at least 2 small parts that are connected. you would have break it off somehow (be careful as said above), move it back and forth or something. it should be easy enough

 

[photonboy]

As said, you simply MOVE it back and forth. At some point the metal will snap making it even easier.

 

[Mocharok]

Thank you all! I'm about to do this but it seems like I've identified the two places "holding" the bracket and what not!