When i play Medieval Dynasty on Max Settings, while running afterburner monitoring. i realise that my GPU temp is around 88-89 Celcius just like 5 minutes into the game, then i checked my GPU fan with HWMonitor and Turns out only 1 fan that running. Bought this GPU 3 years ago. Here is my spec :
Ryzen 5 3600
Kingstone Fury 2x 3200mhz DDR 4
MSI RTX 3060 TI OC V2
Asrock Steel Legend B450
Corsair CV 650
I Decided to open up my GPU, and found out that the thermal already dried up, and the fan is loose like the image attached. I reapplied new thermal paste and i decided to put a double tape on the red circled on the image i attached. Then put it all together again. boot up but the fan wont spin, give it a light touch and it spins but only for 250 RPM and last about 2-3 minutes, tried to push it lightly but it become so hard to push like it sticky.
Is it because the tape ? when i tested it out before putting all it together the fan still spinning so not sticky at all, but when i tried it now it become sticky
Should i go glue it all instead ? will it be okay ?
Is there any other way to fix this without getting a replacement fan ?
Do i just remove the fan and let it run with 1 fan only ?
View: https://imgur.com/a/Eqd37jV
the image of the fan.
Also, before i reapply the thermal and clean the dust, and just doing some browsing the idle temp is 60 degree celcius. now its between 45-50 degree.
Ryzen 5 3600
Kingstone Fury 2x 3200mhz DDR 4
MSI RTX 3060 TI OC V2
Asrock Steel Legend B450
Corsair CV 650
I Decided to open up my GPU, and found out that the thermal already dried up, and the fan is loose like the image attached. I reapplied new thermal paste and i decided to put a double tape on the red circled on the image i attached. Then put it all together again. boot up but the fan wont spin, give it a light touch and it spins but only for 250 RPM and last about 2-3 minutes, tried to push it lightly but it become so hard to push like it sticky.
Is it because the tape ? when i tested it out before putting all it together the fan still spinning so not sticky at all, but when i tried it now it become sticky
Should i go glue it all instead ? will it be okay ?
Is there any other way to fix this without getting a replacement fan ?
Do i just remove the fan and let it run with 1 fan only ?
View: https://imgur.com/a/Eqd37jV
the image of the fan.
Also, before i reapply the thermal and clean the dust, and just doing some browsing the idle temp is 60 degree celcius. now its between 45-50 degree.