How many watts is my PSU?

ButterflyEffect15

Reputable
May 28, 2015
9
0
4,510
I need to know there wattage of my PSU.
I have taken the case off and can't find anything in bold or in the model number, in small writing it says.

Peak: 360w( last for 17 second) also
TOTAL 300W MAX.

I'm planning on installing a GTX 750ti and assuming this will be ok if it is 300w? Thanks
 
Solution
As long as it delivers the rated output it will be fine. You do not have much headroom.

You have 19amps @ 12 volts.

The only "low power" system i have to compare to is my i5 750 + GTX 650ti system. It will not break 180 watts even under very heavy loads. I have a bit more headroom because the power supply has 264 watts @ 12 volts.

It should work, but it on the lower end for sure. Remember modern hardware uses much less power at idle and you have some fairly efficient parts in the system helping keep your power consumption low.
The wattage indeed is 300W. All power supplies can go over their said maximum for a little while, so that is what the "peak" wattage is.

750Ti takes about 80-120W through the motherboard, leaving 220W-180W for everything else so it should be ok.
Cpus don't usually take more than 150W. (high clock cpus like AMD FX-8xxx and Intel i7).
 
Look for a 750ti, which doesn't need an additional 6 pin power plug.
Before upgrading, install up to date NVIDIA drivers and flash the bios of the motherboard to the latest version. Use an USB thumb drive and extract the latest bios file to it. Reboot and enter bios, search for flash or bios update.
Never update bios in Windows!
 


Well, it surely can run GTA V at good enough graphics (1080p 60fps low-mid on GTA V and COD)
But at the same time, it would be better to save up for better gpu and psu.
 
I would not mind an image of your power supply sticker.

While 300 watts is 300 watts. How much of that is on the important 12 volt rail is another question.

The 750ti should not take over 75 watts because it sticks to the older PCI-E specs for power draw. I do not think many companies push this limit because older boards may have issues.

While I agree that a 300 watt power supply should be enough. It depends on the 12 volt out out. It can range from 14-24amps @ 12 volts. This is quite a range from 168 watts to 288watts. This makes a difference because many of the heavy parts of the system run on the 12 volt rail. The CPU/GPU and most of a 3.5 inch hard drive and parts of a motherboard run on 12 volts.

Example image. This 300 watt power supply has a combined 12 volt rail current of 22 amps or 264 watts @ 12 volts.
2yttp1j.jpg
 


65 Watts a PCI lane can only push 75 watts nothing near 120.
 
As long as it delivers the rated output it will be fine. You do not have much headroom.

You have 19amps @ 12 volts.

The only "low power" system i have to compare to is my i5 750 + GTX 650ti system. It will not break 180 watts even under very heavy loads. I have a bit more headroom because the power supply has 264 watts @ 12 volts.

It should work, but it on the lower end for sure. Remember modern hardware uses much less power at idle and you have some fairly efficient parts in the system helping keep your power consumption low.
 
Solution