How should I secure a free-floating HDD

Status
Not open for further replies.

Cowgoesmoo2

Distinguished
Oct 12, 2014
79
3
18,535
My stupid bracket does not fit the HDD, or either my HDD has the SATA oriented wrong.

In any case,

https://ibb.co/eDwB1w

I MUST insert the hard drive blue-side up. This stupid bracket is upside down relative to proper HDD orientation, and even if it didn't, the 1mm of thickness it has seems to make the HDD sit too high to properly fit the mobo.

Anyway so I broke it off.
https://ibb.co/hr2Jgw
A screw was just too tight and was just completely unremovable.

I now have a free-floating HDD which can be easily slid out of place.
https://ibb.co/g9b0uG


Two concerns: How do I not have the hole covered.....?

And how can I keep this hard drive secured...?
 
Solution


That's 2.5" (laptop) and 3.5" (desktop)
In the 2.5" size there is also the thickness. 7mm, 9.5mm, and very large capacity multi-platter 15mm drives.

Return the drive and get the right one. If indeed it is too thick, it will never fit right.

USAFRet

Titan
Moderator


That's 2.5" (laptop) and 3.5" (desktop)
In the 2.5" size there is also the thickness. 7mm, 9.5mm, and very large capacity multi-platter 15mm drives.

Return the drive and get the right one. If indeed it is too thick, it will never fit right.
 
Solution

Cowgoesmoo2

Distinguished
Oct 12, 2014
79
3
18,535
Ahh I've now found out that after securing the mobo the hard drive is at least a milimeter or two high, which puts lots of bending pressure on the connection. I will be installing the bracket and getting a new hdd
 
Status
Not open for further replies.