My watercooler's fans are too big for my RAM profile.
https://www.amazon.com/Team-T-Force-288-Pin-Memory-THWD416G3000HC16CDC01/dp/B06X6CRS7V
My two options seem to be:
Return the Ram and try something with a smaller profile
[strike]or[/strike]
Buy a Dremel, looking at the amazon picture I could cut the one of the points off near the screw (it will fit if I cut it just up to that screw)
Any ideas?
https://www.amazon.com/Team-T-Force-288-Pin-Memory-THWD416G3000HC16CDC01/dp/B06X6CRS7V
My two options seem to be:
Return the Ram and try something with a smaller profile
[strike]or[/strike]
Buy a Dremel, looking at the amazon picture I could cut the one of the points off near the screw (it will fit if I cut it just up to that screw)
Any ideas?