Hello. I have a Dell 1709Wc monitor.
I was using this monitor for this project
View: https://youtu.be/258C19pwXzo?t=323
and tried to use a molex connector for the monitor. I smelt something bad and the screen freaked out. I dont know how, since i felt sure i connected the board properly.
Now the same thing happens if I power it on. White screen with lines. If i unplug the LCD but leave backlight plugged in the lines goe away.
I believe the control board may have a fried chip. This chip is a 2Mbit Flash chip.https://ww1.microchip.com/downloads/en/DeviceDoc/25080A.pdf
The boards schematic is found here. Not the same monitor, but the service manual for this one has a scematic for the same controller in mine.
http://www.go-gddq.com/upload/2013-03/13032620284041.pdf
Pics of board.
View: https://imgur.com/e9iAWZr
View: https://imgur.com/s9U4qCg
Do you think i could replace this chip, or would it need to be programmed? Do you even think that's the issue?
I was using this monitor for this project
and tried to use a molex connector for the monitor. I smelt something bad and the screen freaked out. I dont know how, since i felt sure i connected the board properly.
Now the same thing happens if I power it on. White screen with lines. If i unplug the LCD but leave backlight plugged in the lines goe away.
I believe the control board may have a fried chip. This chip is a 2Mbit Flash chip.https://ww1.microchip.com/downloads/en/DeviceDoc/25080A.pdf
The boards schematic is found here. Not the same monitor, but the service manual for this one has a scematic for the same controller in mine.
http://www.go-gddq.com/upload/2013-03/13032620284041.pdf
Pics of board.
View: https://imgur.com/e9iAWZr
View: https://imgur.com/s9U4qCg
Do you think i could replace this chip, or would it need to be programmed? Do you even think that's the issue?