News How to Store 3D Printer Filament and Keep it Dry

[Admin]

6 storage solutions to keep moisture from ruining your precious stock.

How to Store 3D Printer Filament and Keep it Dry : Read more

 

[LolaGT]

Set bed temp to 55C, lay roll of filament on bed, place glass bowl over roll, wait three hours(PLA).
If you have a printer, you have a built in dryer.
It is easier to keep it dry by not leaving it in the open, then you don't have to use your dryer very often.

 

[TacMonkey]

6 storage solutions to keep moisture from ruining your precious stock.

How to Store 3D Printer Filament and Keep it Dry : Read more

Very concise and comprehensive article. Just need to address the use of mixed units; the text contains liberal references to both imperial and SI units, even when the subject described is the same. Might be a silly thing to remark, ut would it not be better to pick one and stick to it, here its either inches or millimetres, farenheit or celcius, etc. Rather just stick to one.. or even better use both if needed.