[SOLVED] I accidentally disconnected my drive's SATA cable while the PC was on and now it will not boot.

[I'm_a_chicken29]

I was adding a new 1TB hdd to my system(I had a 240gb ssd and a 1tb HDD before this) and I was doing some <Mod Edit> then I pulled the SATA cable for the new hdd while it was on for some reason instead of turning it off and now my pc wont boot any ideas or suggestions on what to do?

 

[rgd1101]

full system spec? include make and model of the psu

try booting with just the ssd?

 

[I'm_a_chicken29]

full system spec? include make and model of the psu

try booting with just the ssd?

Specs are rtx 2060, core i5 9400f, 16gb 2666mhz ram and a 550w psu. For the booting with just the sdd i tried that already

 

[rgd1101]

Specs are rtx 2060, core i5 9400f, 16gb 2666mhz ram and a 550w psu. For the booting with just the sdd i tried that already

missing the make and model of psu and motherboard.

test with just 1 stick of ram.
test with different sata/power cable to the ssd?
test with another psu?

 

[I'm_a_chicken29]

test with just 1 stick of ram.
test with different sata/power cable to the ssd?
test with another psu?

Can only do the ram bc the ssd is a m.2 forgot to say that. And for the psu i don't have another

 

[I'm_a_chicken29]

Did the 1 ram stick only nothing

 

[I'm_a_chicken29]

Update i fixed it i had to uninstall my gpu then take out the CMOS battery wait a min or 2 put it back in and installed the gpu again and it has worked and the drive is now fully installed

 

[sc2lines]

Update i fixed it i had to uninstall my gpu then take out the CMOS battery wait a min or 2 put it back in and installed the gpu again and it has worked and the drive is now fully installed

Cool!!