Question I built a PC and now it has no signal, no beeps.

[ryuuxlol]

Hello everyone, I'm new here but I saw a lot of people recommending tom's hardware as one of the best forums.

Yesterday I built a new PC with the components listed below;

GIGABYTE RTX 5070Ti,
Intel i9 14900k,
32GB DDR5 Corsair Vengeance Ram,
ASUS PRIME H610M-K Motherboard (I know it's the cheapest motherboard you can buy, but I had to skimp out till I could improve it in the future),
Peerless Assassin 120SE ARGB Air Cooler,
Straight Power 11 1000W bequiet! PSU

The problem is, when I boot it up, the fans on the gpu, cpu cooler, and my case start spinning.
The RGB turns on too, however the PC displays no signal.

I've tried taking the CMOS battery out and putting it back in after a bit, plugging an HDMI cable to the motherboard instead of the GPU, double checked if the cables were connected to the motherboard correctly and etc. to no avail. The motherboard supports 14. Gen CPUs as it says on the box, so I'm not sure if it's a BIOS issue. I'd have to get another cpu to check that. It's a 2 slot ram motherboard and I've tried both slots, unfortunately nothing happened.
There is no beeping at all no matter what I do, and I am fairly sure the POWERSW cable and the others are correctly plugged in as I followed the motherboard manual.

I still have no signal on both of my monitors, but they work on my other PC (Display Port cables).

I hope you guys are having a great spring, and I hope you can help me solve this

 

[rgd1101]

take the gpu out and test with igpu?

 

[ryuuxlol]

take the gpu out and test with igpu?

thanks for the reply, i've tried that too to no avail 😕