I got two dash car cameras, and i got a problem for each.

[blueprp]

Hi, for first one:

It is, Blueskysea Novatek G1WH 2.7

When i close my engine that video becomes corrupt. And i can't open that video. So i can open other videos where each one of them are 10 minutes long. But when i park my car and stop the engine, camera also goes offline and that causes to corruption for that single video.

Second One:

B40 A118 Novatek

It says its recording, however as i see it today, it only has old videos in sd card. I couldn't find last few months in it.

So do you know a issue about this? It seems to record (red light-inscreen "capture icon"). But i can't find new videos. It seems there are only old ones.

Anybody know about these issues? I try to change settings but it didn't change anything.

 

[Jen_Sai]

Perhaps stop recording before switching off engine
By cutting the power it may not have enouh to finalize the writing of the file, leaving it corrupted 🙁

I have a remote for my dash cam and it charges seperatly from the car output, except on the rare occasions that it's run otta juice.
Perhaps it could possibly even be the memory card, check it's working, not locked try different card?

 

[blueprp]

Perhaps stop recording before switching off engine
By cutting the power it may not have enouh to finalize the writing of the file, leaving it corrupted 🙁

I have a remote for my dash cam and it charges seperatly from the car output, except on the rare occasions that it's run otta juice.
Perhaps it could possibly even be the memory card, check it's working, not locked try different card?

Yes i think that would work but i mostly would forgot each time. I don't have any other sd cards to try, maybe i can clean them up and try again.