Question I have a BeQuiet! 600LX case and have some Q's on where some of the cables go and where they plug into.

[mazzar-el]

This case was delivered to me to populate. Their documentation is either non-existent and or horrible when you can find anything. And it is basically all GENERIC (and monochromatic) pictures rather than actual text descriptions to go along with the photos.

Anyone have experience building one of these cases with an MSI motherboard? I'm a bit stuck and do NOT want to start pluging cables in w/o some information as this is NOT my system.

Thanks.

 

[Lutfij]

Welcome to the forums, newcomer!

Perhaps this might be of assistance to you;

View: https://www.youtube.com/watch?v=K4qaXbvSZww

That being said, what parts are you trying to populate inside the case?

 

[mazzar-el]

This is a fairly bare bones install. The MoBo is an MSI Z790-S Pro with only two memory slots populated with
CORSAIR VENGEANCE DDR5 RAM 32GB (2x16GB) 6000MHz, SAMSUNG 990 EVO Plus SSD 2TB, i7-12700K processor, a 750 Corsair RX750 PS, and a 5 pipe tower cooler w/dual fans. There will be no overclocking. I believe that at some point, a GPU may be added, but nothing planned as of yet. My question concerns the "extra" cables at the rear of the case (that came as part of the case. They are very likely somehow connected to the upper and lower LED hubs. With all of the wiring it is difficult to tell where 2 of the cables that look like hub cables are supposed to be connected (are they supposed to be connected somewhere to the motherboard?). I have not yet connected ANY fans to the MoBo discretely. So I guess I am looking for some interface info so that I do not burn up the case or MSI MB as they do NOT belong to me.

Thanks.

​

​

BTW, I've looked at almost 1/2 dozen videos, including the one suggested, which appears to be the best of them. It is a very well done video and does give more info, but still leaves me with questions.

This is what I was looking for...

View: https://www.youtube.com/watch?v=RYkW2WywN5I