If some pins on the AMD FX 6300 are bent around 70-80°, if placed right in the motherboard, will it work?

[Iamsodumb]

I recently got an FX 6300 for free (techsource tech meetup, thanks ed!) And I was looking at the pins and it seems like 3 or 4 pins are bent very slightly, to the point where you it's visible, but only close up. these pins are bent around 70 to 85° so, will it work, I already have a pretty good gaming computer myself, so I wanted to build my friend a pc, his pc SUCks, even on MINECRAFT he gets around 30 fps. Ill link the parts list .

https://pcpartpicker/list/JGPWqk

Just copy and paste that into your browser THANKS! * MY FRIEND is going to pay for all of the parts except the processor and case (I got both for free fx 6300 and diypc case) but other than that I don't have any part except the processor and case. Kind of confusing but I'm sure you guys can figure it out.

 

[mdd1963]

Insert a tiny mechanical pencil tip (without lead) around it, and straighten them....; the pins being a fraction off can damage the mainboard socket, crushing the plastic socket with the bent pin, permanently ruining it...

 

[CountMike]

As long as it can go into socket properly, there's nothing to worry about. Once you snap the handle on socket holder it makes enough pressure on the pins to straighten them out. Unless some pin is missing that shouldn't be a cause of any problems.

 

[SkyBill40]

As suggested, very carefully, attempt to straighten the pins. So long as none have broken from the CPU, you would be just fine.

 

[Iamsodumb]

Thanks guys will try it out

 

[CountMike]

If it goes in the socket, don't straighten them, there's a chance they might brake.