I'm organizing my life with a 3D printer and Bento3D — here's how you can build your own organizer

[Admin]

With a few measurements, an idea and a 3D printer, you can organize (most) of your life.

I'm organizing my life with a 3D printer and Bento3D — here's how you can build your own organizer : Read more

 

[ad9fd]

The two most important steps were left out. Namely #1 check how much its going to cost and #2 do a quick check to see if it's cheaper just to buy something better for less money.

 

[USAFRet]

The two most important steps were left out. Namely #1 check how much its going to cost and #2 do a quick check to see if it's cheaper just to buy something better for less money.

As the owner and user of more than 1 3D printer, 'cheaper' is not always the quest.

 

[SonoraTechnical]

This article might be the 'Jumped the Shark' moment for Toms Hardware.

 

[USAFRet]

This article might be the 'Jumped the Shark' moment for Toms Hardware.

Why?

I will almost certainly use that resource to design a couple of small 'toolboxes'.
I already have the printer(s).

 

[SonoraTechnical]

Why?

I will almost certainly use that resource to design a couple of small 'toolboxes'.
I already have the printer(s).

I'm not going to debate you. My comment stands as the snarky dry humor it was intended to be.

 

[USAFRet]

I'm not going to debate you. My comment stands as the snarky dry humor it was intended to be.

OK.
But I've seen MUCH more sharkiness around here than this writeup.