[SOLVED] Installed new ram and no display

[Francis064]

Hi everyone,

I just bought 2x8gb ram tforce delta blitz running at 3200mhz. I installed it and made sure that its properly seated but i get no display. Do you guys think its not compatible with my board? The reason i bought it is in preparation for upgrading my setup to ryzen but i wanna figure out if its just incompatible or defective?

My current specs is
I7-6700 (non K)
Asus h110m-v motherboard
Palit storm x Gtx 1660 super
Aerocool 600w power supply
1x 4gb gloway 2400 mhz ram
1x 4gb zeppelin 2133mhz ram

I tried reinstalling my old ram and i get a display but when i use my t force ram, i get nothing. There is power cause my fan lights light up and my gpu fan runs. Please help!

 

[ChumP]

Have you tried each of the new sticks individually?... there maybe a problem with one of the modules.

 

[Deleted member 14196]

Try installing new kit. Then reset CMOS

 

[Francis064]

Have you tried each of the new sticks individually?... there maybe a problem with one of the modules.

I will try this one. But this is supposed to run on my board right? It will just lower the frequency?

 

[Francis064]

Try installing new kit. Then reset CMOS

I already did this. Im still getting no display.

 

[Deleted member 14196]

OK then do as above and try it with one stick at a time

 

[ChumP]

I will try this one. But this is supposed to run on my board right? It will just lower the frequency?

Even if 3200 MHz is out of your motherboard spec, when installed every ddr4 kit(no matter the frequency) will default at 2133 MHz. Enabling XMP will get you to the rated frequency of the kit(if your motherboard supports it).

 

[Francis064]

OK then do as above and try it with one stick at a time

Thank you so much! Somehow, it worked when i placed the modules 1 by 1.

 

[Francis064]

Even if 3200 MHz is out of your motherboard spec, when installed every ddr4 kit(no matter the frequency) will default at 2133 MHz. Enabling XMP will get you to the rated frequency of the kit(if your motherboard supports it).

Thak you so much! I fixed the issue by installing the modules 1 by 1

 

[ChumP]

Thak you so much! I fixed the issue by installing the modules 1 by 1

So now both modules from the new kit are in?

 

[Francis064]

So now both modules from the new kit are in?

Yep and it worked! Thanks!

 

[ChumP]

Yep and it worked! Thanks!

Most likely one of the modules wasn't inserted fully.

 

[blackjoker]

Most likely one of the modules wasn't inserted fully.

Sir is there any alternative solution for this problem? Because I tried all what you said above and still didn't fix my no signal monitor