Okay, I am new to ocing and I want to see if my settings and temps look okay. I have the above mentioned cpu running on a z77 extreme4 board cooled by a Corsair H55 (soon to be push/pull).
BIOS Settings:
Ratio: All Core
Multiplier: 44
Speed Spectrum: Disabled
Speedstep: Enabled
Turbo Boost: Enabled
Additional Turbo: Auto
PLL Overvoltage: Enabled
Long Duration: 500
Duration Maintained: 1s
Short Duration: 500
Primary Plane: Auto
Secondary Plane: Auto
C1e: Enabled
C3: Disabled
C6: Disabled
Package C: Disabled
Ram Config: Auto
Voltage Config:
Power Saver: Disabled
CPU Voltage: Offset
Offset Voltage: -0.065
LLC: Level 2
Everything else is on Auto
Using Intel Burn Test
Max Temps: 73 degrees
Max Voltage: 1.209v
No errors in prime95 under very short testing
No WHEA errors
I had WHEA errors when I dropped to voltage to -0.070v, but none at -0.065v.
Should anything be changed??
I do not want to damage my chip.
Please tell me if I'm doing anything wrong!
BIOS Settings:
Ratio: All Core
Multiplier: 44
Speed Spectrum: Disabled
Speedstep: Enabled
Turbo Boost: Enabled
Additional Turbo: Auto
PLL Overvoltage: Enabled
Long Duration: 500
Duration Maintained: 1s
Short Duration: 500
Primary Plane: Auto
Secondary Plane: Auto
C1e: Enabled
C3: Disabled
C6: Disabled
Package C: Disabled
Ram Config: Auto
Voltage Config:
Power Saver: Disabled
CPU Voltage: Offset
Offset Voltage: -0.065
LLC: Level 2
Everything else is on Auto
Using Intel Burn Test
Max Temps: 73 degrees
Max Voltage: 1.209v
No errors in prime95 under very short testing
No WHEA errors
I had WHEA errors when I dropped to voltage to -0.070v, but none at -0.065v.
Should anything be changed??
I do not want to damage my chip.
Please tell me if I'm doing anything wrong!