Intel i5-4570 idle temperature?

[Guest]

I just finished a build with i5-4570 using the stock cooler.
Case: CoolerMaster Silencio 352.
Mobo: AsRock B85M Pro4.
SpeedFan shows both case fans running at full speed 1150-1200rpm.
Cpu fan full speed too 1170 rpm
I can see cpu idle temps around 43 C with room temp at 22 C. Pretty warm, isn't it? Did I botch the cooler installation? Am I supposed to expect for the heat transfer paste to settle for some time or what?

Other grievance is the noise of this Silencio case. The Cooler Master stock fans make a lot of noise. Case is also resonating/vibrating. I checked my cable management. They are not near the fans and they are not pressing against the side walls, so the vibration must come from the case fans.

Obviously CM did not use plastic/silicon when attaching the fans to the case. Does anyone have experience with these fans? CM XtraFlo 120mm, no leds. Are they any good? Should i switch them?

If I have reapply thermal paste, I might get a cooler at the same time, if it solves any issues. This case allows for max 155mm cooler height.
How about CM Hyper TX3 EVO cooler? I could get that for 25€. Is this gonna be LOUD because of the small fan diameter? Am I going to see any improvements in temps and noise?

 

[z0rr0w]

43 doesnt seem out of the ordinary to me, my overclocked 4770k runes at around 35 C idle with a h100i cooler+ my room is closer to 19 C than 22 so i'd say everything is fine. You should watch your load temps as they mean more, try not to exceed 70 C under full load.

 

[Zircoben]

I just finished a build with i5-4570 using the stock cooler.
Case: CoolerMaster Silencio 352.
Mobo: AsRock B85M Pro4.
SpeedFan shows both case fans running at full speed 1150-1200rpm.
Cpu fan full speed too 1170 rpm
I can see cpu idle temps around 43 C with room temp at 22 C. Pretty warm, isn't it? Did I botch the cooler installation? Am I supposed to expect for the heat transfer paste to settle for some time or what?

Other grievance is the noise of this Silencio case. The Cooler Master stock fans make a lot of noise. Case is also resonating/vibrating. I checked my cable management. They are not near the fans and they are not pressing against the side walls, so the vibration must come from the case fans.

Obviously CM did not use plastic/silicon when attaching the fans to the case. Does anyone have experience with these fans? CM XtraFlo 120mm, no leds. Are they any good? Should i switch them?

If I have reapply thermal paste, I might get a cooler at the same time, if it solves any issues. This case allows for max 155mm cooler height.
How about CM Hyper TX3 EVO cooler? I could get that for 25€. Is this gonna be LOUD because of the small fan diameter? Am I going to see any improvements in temps and noise?

I have a Hyper TX3 and it's amazing. It is very quiet on my relatively hot AMD A10-5800K.

In my Cooler Master N200 case, I have PLENTY of room still, and I wish I would have gotten the Cooler Master Hyper 212 EVO. It looks like the 212 EVO is just a little too big for your case though (159mm).

I would go for the TX3. It is incredible. It eliminated this sound coming out of my computer, and it should make your noise and temps go download quite considerably.

Good luck!

 

[Guest]

Sorry for being so late for picking the solution. I did not get any notification about the answers. I was looking for them and it always showed 0 responses.