Question Is GTX 1660Ti sufficient for running CATIA/NX?

eviltothecore94

Reputable
Jun 13, 2016
13
0
4,510
0
Hi folks,

I am planning on building a PC which will be used for CAD and occasional gaming. ( I have been telling that for a couple of years)

I was researching about the possibility of running Both Quadro and GTX graphics in a single system.

After reading I have come to the bitter conclusion it cannot be done effectively at least in my case.

So the question is whether can I run CATIA. Siemens NX, Altair Hyperworks,etc for educational purposes.

The system must able to efficiently load max of 100 parts without stuttering.

I have taken care of the CPU and RAM (Ryzen 5 3600X and 16GB)

Is there any other way other than sacrificing the gaming by opting for a Quadro?

Also will RX580 8GB perform the same way as it now way cheaper in my location.

Your insights are welcome

Thanks in advance
 

ASK THE COMMUNITY

TRENDING THREADS