Hi there,
I have bought a new motherboard and a processor today.
It is MSI H97 GAMING 3 and INTEL i5-4690.
Now, firstly, I wishes to test first boot of my system.
I installed RAM and CPU properly, and attached the power cables to mobo. But the problem is that, it starts Like this, CPU fan first moves and stops, then for second time it moves and stops, then for third time it runs properly. But Im not getting any display in my monitor.
Surely its not fault of mobo and processor, as they are brand new.
My PSU is Corsair VS550. I thought i would be a fault of PSU, so performed some test on PSU as follows,
I joined green and black (15,16 wire), the psu started.
Now with some test on multimeter, i think its voltage tolerance test or voltage regulation test (don't knoe excatly).
I found all wires (RED , BLUE, PURPLE) giving good voltage within minimum voltage and maximum voltage EXCEPT wire ORANGE (voltage rail +3.33VDC).
It should be between +3.135 and +3.465, but i found a reading of +2.74 VDC on my multimeter.
Guys, what do you think?
Is it all right, or is my psu responsible for no booting of my system?
Please give your valuable solutions.
I have bought a new motherboard and a processor today.
It is MSI H97 GAMING 3 and INTEL i5-4690.
Now, firstly, I wishes to test first boot of my system.
I installed RAM and CPU properly, and attached the power cables to mobo. But the problem is that, it starts Like this, CPU fan first moves and stops, then for second time it moves and stops, then for third time it runs properly. But Im not getting any display in my monitor.
Surely its not fault of mobo and processor, as they are brand new.
My PSU is Corsair VS550. I thought i would be a fault of PSU, so performed some test on PSU as follows,
I joined green and black (15,16 wire), the psu started.
Now with some test on multimeter, i think its voltage tolerance test or voltage regulation test (don't knoe excatly).
I found all wires (RED , BLUE, PURPLE) giving good voltage within minimum voltage and maximum voltage EXCEPT wire ORANGE (voltage rail +3.33VDC).
It should be between +3.135 and +3.465, but i found a reading of +2.74 VDC on my multimeter.
Guys, what do you think?
Is it all right, or is my psu responsible for no booting of my system?
Please give your valuable solutions.