G
Guest
Guest
hi guys i am new at oc so i want to know if these settings are right
intel speedstep tech :enabled
intel turbo mode : enabled
bclk : 155
PCIE Frequency : 100
Dram Frequency : DDR3-1554MHZ
UCLK frequency: 3107MHZ
QPI LINK Data Rate : 5594MT/S
DRAM TIMING 8-8-8-24
cpu voltage: 1.06250
CPU PLL VOLTAGE: 1.80
QPI/Dram core voltage:1.20625
IOH Voltage : auto
IOH pcie Voltage auto
ICH Voltage: auto
ICH PCIE Voltage: auto
DRAM BUS VOLTAGE : 1.64
DRAM DATA REF VOLTAGE ON CHA: AUTO
DRAM CTRL REF VOLTAGE ON CHA :AUTO
DRAM DATA REF VOLTAGE ON CHB :AUTO
DRAM CTRL REF VOLTAGE ON CHB :AUTO
DRAM DATA REF VOLTAGE ON CHC :AUTO
DRAM CTRL REF VOLTAGE ON CHC :AUTO
LOAD LINE CALIBRATION : AUTO
CPU Differential amplitude : auto
cpu clock skew : auto
cpu spread spectrum : auto
IOH clock skew : auto
PCIE spred spectrum : auto
c1e support: enabled
i wanna to know if i must disable the speedstep or i can leave it enable
and also vdroop
i noticed that when i disable the vdroop the vcore decrease in preassure than the value i choose in the bios and in idle it increase to the value which i choose in the bios
and if i must disable the c1e , vdroop ,cpu spread spectrum , pcie spread spectrum why i must disable it
i read also that the difference bet the ram volt and uclk volt must be equal to 0.5 or less than it is it right?
thank for ur help
intel speedstep tech :enabled
intel turbo mode : enabled
bclk : 155
PCIE Frequency : 100
Dram Frequency : DDR3-1554MHZ
UCLK frequency: 3107MHZ
QPI LINK Data Rate : 5594MT/S
DRAM TIMING 8-8-8-24
cpu voltage: 1.06250
CPU PLL VOLTAGE: 1.80
QPI/Dram core voltage:1.20625
IOH Voltage : auto
IOH pcie Voltage auto
ICH Voltage: auto
ICH PCIE Voltage: auto
DRAM BUS VOLTAGE : 1.64
DRAM DATA REF VOLTAGE ON CHA: AUTO
DRAM CTRL REF VOLTAGE ON CHA :AUTO
DRAM DATA REF VOLTAGE ON CHB :AUTO
DRAM CTRL REF VOLTAGE ON CHB :AUTO
DRAM DATA REF VOLTAGE ON CHC :AUTO
DRAM CTRL REF VOLTAGE ON CHC :AUTO
LOAD LINE CALIBRATION : AUTO
CPU Differential amplitude : auto
cpu clock skew : auto
cpu spread spectrum : auto
IOH clock skew : auto
PCIE spred spectrum : auto
c1e support: enabled
i wanna to know if i must disable the speedstep or i can leave it enable
and also vdroop
i noticed that when i disable the vdroop the vcore decrease in preassure than the value i choose in the bios and in idle it increase to the value which i choose in the bios
and if i must disable the c1e , vdroop ,cpu spread spectrum , pcie spread spectrum why i must disable it
i read also that the difference bet the ram volt and uclk volt must be equal to 0.5 or less than it is it right?
thank for ur help