[SOLVED] Is this correct for front panel connectors?

[ironcreeper2004]

The board in the picture is a B450 Steel Legend MATX. On the far left I've connected the cable labeled "USB" there, on the far right I've connected the PLED+, PLED-, HDLED+-, PWR and RESET. The PLED plus and minus are in the top left, the HDLED+- is in the bottom left, the PWR is in the top right and the RESET is in the bottom right.

https://ibb.co/F8xDPB1

Sorry if I didn't describe this well, thanks for any help.

 

[siaan312]

There should be a diagram either somewhere on the board, or in the manual for exactly where and how to put them.

 

[ironcreeper2004]

There should be a diagram either somewhere on the board, or in the manual for exactly where and how to put them.

Yea that's what I followed, just paranoid it's wrong.

 

[ironcreeper2004]

Yea that's what I followed, just paranoid it's wrong.

Paranoid I misinterpreted it*

 

[Furzumz]

Matching your description to the manual it sounds right

It doesn't say which pin is for the + or - for the PLED (power indicator light) but worst case scenario the power indicator won't work and you'll just have to move the connector to the proper + and - pins

 

[siaan312]

Yea that's what I followed, just paranoid it's wrong.

Even if you get the pins wrong, nothing will happen.
They'll just not work and you need to try again.

 

[ironcreeper2004]

Even if you get the pins wrong, nothing will happen.
They'll just not work and you need to try again.

They worked! Cheers for the help.