Question Just built my mining rig and everything powers up, but monitor doesnt get signal.

[l0lgaber]

Specs:
Asrock h110 pro btc+
Intel core i5 6500
Corsair value select 2133mhz 8gb


I plugged my 1070 ti in the x16 slot and double checked if everything is plugged in and everything lights up and all the fans spin but it still wont show up on monitor. I have tried to reset CMOS but it didnt work.

 

[sizzling]

Is the monitor connected to the gpu and not the motherboard? If the gpu has multiple power sockets are all connected?

 

[l0lgaber]

Is the monitor connected to the gpu and not the motherboard? If the gpu has multiple power sockets are all connected?

Yes the monitor is connected to the GPU I tried with both HDMI and DVI. And all of the sockets for GPU are connected.

 

[sizzling]

If you take the gpu out does the system run on the integrated graphics?

 

[l0lgaber]

If you take the gpu out does the system run on the integrated graphics?

 

[l0lgaber]

Its the same. There is no signal as it says on the monitor.

 

[Idris9274]

Hi
I always have the same problem most of the time.
If you can get a cheap GPU which supports GPU for the screen it will help 100% .I use Radeon HD 5450 To solve this always.

but if you want to get the screen with your main GPU you can try this too and I believe it works (worked for me always)

1- turn off power button
2-unplug the power cord
3-take out CMOS Battery
4-now press power button on case and hold it for 20-40 seconds it will drain the power and then plug everything back and power on