[SOLVED] Leaving 1 Standoff

[Ahmed.K]

1 of the standoff for my case won't fit, Is it ok if I leave only 1 of the standoff for my ATX motherboard case

 

[gamerbrehdy]

I was able to install the other standoffs, but the hole for 1 of the standoff is smaller than it is suppose to be, that's all
And returning the case for 1 standoff might be difficult

Unless the information about the case states that one standoff won't fit, returning the case is a reasonable and acceptable thing to do.

You could widen that standoff hole in some way, but it's not recommended to do this.

 

[SkyNetRising]

Can you show a photo?
If a standoff doesn't fit (there is no corresponding screw hole in motherboard), then standoff has to be removed or it can cause short.

 

[gamerbrehdy]

You'll lose some stability in the motherboard, and there is indeed a chance of shorting some contacts on the back.

 

[Ahmed.K]

Can you show a photo?
If a standoff doesn't fit (there is no corresponding screw hole in motherboard), then standoff has to be removed or it can cause short.

I was able to install the other standoffs, but the hole for 1 of the standoff is smaller than it is suppose to be, that's all
And returning the case for 1 standoff might be difficult

 

[Ahmed.K]

8 standoffs are installed, 1 at the middle right is not fitting

 

[SkyNetRising]

Then you have to remove the standoff.

 

[gamerbrehdy]

I was able to install the other standoffs, but the hole for 1 of the standoff is smaller than it is suppose to be, that's all
And returning the case for 1 standoff might be difficult

Unless the information about the case states that one standoff won't fit, returning the case is a reasonable and acceptable thing to do.

You could widen that standoff hole in some way, but it's not recommended to do this.

 

[hftvhftv]

Can you provide photos of the stand off and the hole it is supposed to go into?

 

[Ahmed.K]

Unless the information about the case states that one standoff won't fit, returning the case is a reasonable and acceptable thing to do.

You could widen that standoff hole in some way, but it's not recommended to do this.

Done, It was a cheap case(not too expensive), So I hammered a nail into the standoff hole, and the hole got widened, and the standoff now fits(but a little loose)