Logitech headset G930 Mainboard

Snowh1te

Reputable
Jan 14, 2016
1
0
4,510
A little piece on the mainboard of my G930 has brokded. I dont really know the name or purpose if this component, but i think it has something to do with the power supply,It says SW2 in white beside it. I was wondering if you had ant idea if it is possible to change it, or the whole mainboard if i must. ty 😀
 
Solution
The swapping out of the mainboard may result in the entire headset malfunctioning or worse being inoperable. I'd suggest you hold it on via a hot glue gun or some duct tape. if the part broke off due to normal usage then you're entitled to an RMA as this would indicate a defective unit from the factory provided it's covered under warranty...?

Since you're interested, here's a link to a spare PCB while here's a guide to disassembling it. The part that most likely might've broken off is your micro USB port which for everyone on the same boat as you state the solder was badly done on the headset.

c70df357_ibab0Qyk7lmpU1.png

Further reading.
The swapping out of the mainboard may result in the entire headset malfunctioning or worse being inoperable. I'd suggest you hold it on via a hot glue gun or some duct tape. if the part broke off due to normal usage then you're entitled to an RMA as this would indicate a defective unit from the factory provided it's covered under warranty...?

Since you're interested, here's a link to a spare PCB while here's a guide to disassembling it. The part that most likely might've broken off is your micro USB port which for everyone on the same boat as you state the solder was badly done on the headset.

c70df357_ibab0Qyk7lmpU1.png

Further reading.
 
Solution