Looking for good CPU coolers that fit in an Antec 900

arfows

Distinguished
Nov 13, 2008
29
0
18,530
Hey all,

First time builder. Scoping the forums to see what kind of cooler to throw onto my proc. I've obviously never done it before, so I am looking for something that:
1) fits in my case & mobo
2) is not too difficult to install
3) is relatively quiet
4) <$50, although cheaper is better ;)

I plan on doing mid level or maybe a little higher Oc'ing. Also, does the brand/type of thermal paste make a difference?

Here is my rig:
Antec 900
Gigabyte EP45-UD3P
E8500

Here are the two that I am looking at, but don't know if there is anything better out there:

1) Xigmatek HDT s1283

2) Artic Cooler Freezing 7 Pro

Thanks in advance!
 

kyeana

Distinguished
May 21, 2008
1,290
0
19,310
most defenatally get the xiggy s1283, much better then the arctic freezer!
http://www.newegg.com/Product/Product.aspx?Item=N82E16835233003&Tpk=s1283
Make sure to get the retention bracket along with it so you dont have to use the push pins
http://www.newegg.com/Product/Product.aspx?Item=N82E16835233019
For thermal paste i find that arctic silver 5 works very well
http://www.newegg.com/Product/Product.aspx?Item=N82E16835100007

As for applying the thermal paste with the s1283, you can't use the normal method (on arctic silvers website) because the paste will just go into the cracks caused by the direct contact of the heat pipes of this heatsink. Someone on this forum did some testing on this (i don't remember who but i can't take any credit) and found that if you put a very small amount of thermal paste on each of the heat pipes then it spread nicely and gives you ideal temps

Good luck!
 

kyeana

Distinguished
May 21, 2008
1,290
0
19,310


The arctic freezer 64 pro is the same product as the arctic freezer 7 pro, the only difference being that the 64 is for amd systems and the 7 is for intel system.

As for temps differences the s1283 still offers better cooling then the arctic freezer 7 so i would have to recommend that.
 

arfows

Distinguished
Nov 13, 2008
29
0
18,530
Thanks thus far!


I've done some more searching...any thoughts about the OCZ Vendetta? Would it work without a fan?
 

brendano257

Distinguished
Apr 18, 2008
899
0
18,990
Cooler Master Hyper TX2 is what I'm using in my Antec 900 right now, it's got atleast 1-
1 1/2 inch clearance from the door and keeps my E8400 idle low 30's and load 40's rarely 50's.
 

arfows

Distinguished
Nov 13, 2008
29
0
18,530
Is the S1283 loud enough to hear over the case fans? I am trying to get a pretty silent rig here, and I think this cooler might fall out of favor due to its noise production. Anyone with experience with it care to confirm or deny the noise issue? Thanks
 

bobbknight

Distinguished
Feb 7, 2006
1,542
0
19,780
Ok before you go and get all riled up about the various coolers you should know for an air cooler there is one better of the 2 you have listed.

It is the Xigmatek HDT S1284EE

Cooling ability is measured in Thermal Resistance

The Arctic Cooling Freezer Pro 7 is 0.17°C/Watt

The Xigmatek HDT-S1283 is 0.16°C/Watt

The Xigmatek HDT-S1284EE is 0.14°C/Watt

The Xigmatek bracket should be used for the Xigmatek cooler.

The freezer pro will be more quiet than either of the Xigmateks.
The HDT-S1284EE does as good as some of the $200 water cooling rigs.
What I like about the Freezer 7 Pro is that it's very cost effective. Great Bang for Buck.

LOL the freezer pro 64 not for a skt 755 lol
 

kyeana

Distinguished
May 21, 2008
1,290
0
19,310
Whatever cooler that was it apparently has been deactivated (or its a bad link). Regardless the s1283 offers amazing cooling, so if you get a case and mobo that it fits in i would still have to recommend it.