Marvell bios RAID utility

[didcrywolf]

I have an Asus P6T -ws mobo which used to be setup with a raid 1 array on the marvell controller. When i tried to install a second video graphics card, every drive on the system lost its place. I cannot boot the system anymore into any OS and I suspect unless I get the array back, I won't be able to use the system.

My QUESTIONS:
1) Can I just pull out one of the array 1 drives and stuff in another machine and see if it holds any data?
2) What does the command "Disk verify" actually do in the Marvell bios utility (under CTRl-M)
3) How can i recreate an array 1 when both drives show up as FREE under the marvell bios RAID menu?

thank you for your responses

 

[didcrywolf]

I Should point out the RAID 1 array does not contain the OS . That is held on a separate SDD.
lastly the reason why I need to look at the data on the Raid 1 drives is because I have three 1TB drives two of which made up the array with valuable data, the third drive was a bootable drive. I want to make sure that as part of the solution i do not use the boot drive to erase one of the data drives...
i knew this would get complicated.....

Thanks again!