Marvelladapter

[ferrie]

startup the computer, get normal startup screen. then gives marvell adapter88SE61 initialising. next screen : starting windows and then shuts down and restarts again.

info: put in motherboard msi p35


any suggestions??

i've tried following: disconnecting ide dvd burner
no luck. changing master/slave setting also no esult.

i've done a system restore : nothing

done checking errors: no errors found

hope someone has a solution

thanks

ferrie altorf

 

[henydiah]

RMA...!

 

[ferrie]

RMA?

 

[Snipergod87]

RMA...!

You could also be more helpful I dont think RMA is the right choice yet, you havent even done any trouble shooting.

You see the marvell adaptor initializing before it loads windows? if so that is normal, my computer has 2-3 screens on varios addon cards initializing on boot.

That Marvell adapter is your hard drive controller on the motherboard. Does it say anything about hard disks? If it does than you problem may be else where.

From what I understand Windows does get to the startup screen than crashes right? There are two likely culprits.
1) A stick of RAM has gone back, you could try using one stick of RAM at a time and try different sticks in different slots. If that solves the problem than it was probably some RAM gone bad.
2) Your Windows install got corrupted. What version of Windows are you using?

 

[ferrie]

1. thanks i'm gonna try changing the RAM
2. i have windows 7 and this was working perfectly before i chaned the motherboard, so i don't think it got corrupted.

i let you know my findings after changing slots and sticks

 

[Snipergod87]

You changed the motherboard than that probably did it. Is it the same model motherboard or a new one? Typically when you change motherboards (different models) the chipset is different so you would need to to a complete reinstall of Windows, since your computer is trying to load the drivers from the old motherboard which is causing it to crash.

On your old motherboard was you SATA controller set to IDE, AHCI or RAID. If windows was installed on AHCI than you switch to IDE or RAID it may not work. Same thing the other way around, IE: id you isntalled on IDE, and have switched to AHCI or RAID.

I have gone though several motherboard replacements sometimes poping my hard drive into the new system works but often enough it doesnt.

Alternativly if you dont want to try a reinstall yet you can try booting into safe mode if you can get in there download Driver Sweeper and run that, and install your new drivers too.

Keep us updated!

 

[ferrie]

Snipergod87,

thanks very much for your advice, i never thought of that!
i did a new instal lof windows and everything is working smoothly again!

thanks again

ferrie

 

[Snipergod87]

No problem. Sometimes it Windows will still work but most of the time it doesn't.

To close this thread you should click "Mark as Best Answer" for the post that helped you.

 

[ferrie]

Best answer selected by ferrie.