Hi
I'm trying to upgrade the 256k memory in my mom's old dell 1100.
Dell's documentation identifies the current memory as -- Dual Inline Memory Module 256,400M,32X64 8K,184
It has a celeron processor 2.53Ghz with 2 memory slots capable of 1GB each.
I purchased a 2GB kit of corsair memory CMX1024-3200C2PT -- pc3200, non-ecc.
After installing the new memory the computer will not boot. It gives me a series of beeps, that is all. I believe this is referred to as "posting" or not posting in this case.
The only incompatibility issue I can come up with is the old memory is cl3, the new is cl2, but from what I've read that shouldn't be a problem as it should just run at the cl3 speed. I've tried one stick at a time - in either slot, no difference.
Corsair does offer some bios memory settings, but the only setting I can find to modify in the system's set up is the setting for graphics.
Corsair also suggests a voltage of 2.75, I believe the current voltage is lower than that. Could that be a problem?
I'm lost.
I hope somebody can offer some guidance.
I'm trying to upgrade the 256k memory in my mom's old dell 1100.
Dell's documentation identifies the current memory as -- Dual Inline Memory Module 256,400M,32X64 8K,184
It has a celeron processor 2.53Ghz with 2 memory slots capable of 1GB each.
I purchased a 2GB kit of corsair memory CMX1024-3200C2PT -- pc3200, non-ecc.
After installing the new memory the computer will not boot. It gives me a series of beeps, that is all. I believe this is referred to as "posting" or not posting in this case.
The only incompatibility issue I can come up with is the old memory is cl3, the new is cl2, but from what I've read that shouldn't be a problem as it should just run at the cl3 speed. I've tried one stick at a time - in either slot, no difference.
Corsair does offer some bios memory settings, but the only setting I can find to modify in the system's set up is the setting for graphics.
Corsair also suggests a voltage of 2.75, I believe the current voltage is lower than that. Could that be a problem?
I'm lost.
I hope somebody can offer some guidance.
