Micron 9100 Max NVMe 2.4TB SSD Review

Status
Not open for further replies.

Flying-Q

Distinguished
Feb 20, 2006
643
7
19,065
If the flash packages are producing so much heat that they need such a massive heatsink, why is there only one? Surely the flash on the rear of the card would need heatsinking too, even just a flat plate would suffice?
 

PaulAlcorn

Managing Editor: News and Emerging Technology
Editor
Feb 24, 2015
858
315
19,360


This is a standard configuration, though there are a few SSDs that have rear plates. Thermal pads were more common with larger lithography NAND, 20nm, 25nm, etc, because it generated more heat. New smaller NAND, such as the 16nm here, draws less power and generates less heat. In fact, it was very common with old client SSDs to have a thermal pad on the NAND, whereas now they are relatively rare. I think that they may be relying upon reducing the heat enough on one side to help wick heat from the other side, but the heatsink is primarily for the controller and DRAM with the latest SSDs. Also, it may just be convenient to add additional thermal pads to the NAND to keep the spacing for the HS even across the board.
 
Status
Not open for further replies.