Question Monitor detects signal only after windows logo.

[mzk777]

It says "no signal detected" until my computer is fully booted up. the thing is i want to access bios. I experienced this 2 days ago but it got fixed on it's own after few restarts.
Monitor: BenQ XL2411z
GPU: GTX 1060
I'm using a DVI-D cable.
I tried using a HDMI cable the monitor but didn't detect any signal at all. although it did work when i connected my PC to my TV using HDMI.

 

[RARRAF]

the only thing I can suggest is try a displayport cable.

 

[cherry blossoms]

If fast startup is enabled , try disabling it.

You can also try disabling the hibernation system and setting power to fully shutdown

 

[mzk777]

the only thing I can suggest is try a displayport cable.

My xl2411z doesn't have a dp port. I tried an HDMI on my TV it worked normally. I guess it's either the monitor , the cable or one of the DVI ports.

If fast startup is enabled , try disabling it.

You can also try disabling the hibernation system and setting power to fully shutdown

No it's not enabled. I just turned hibernating off i will give it a try and keep you updated.
Thanks for the replies guys.

 

[mzk777]

If fast startup is enabled , try disabling it.

You can also try disabling the hibernation system and setting power to fully shutdown

Sadly it didn't work my monitor won't detect any signal sometimes

 

[brookliner]

Do you only use one monitor for your pc?

 

[mzk777]

Do you only use one monitor for your pc?

Yes i do