The 750 has 2 stock 140mm in the front. I'm yanking those and putting a 240 push pull AIO in its place in the front. I want to slide it up as much as possible because I'm also adding 2 120mm intakes in the bottom, one of which will be slightly roughly half under the push pull. So by sliding it up, the 2 bottoms can get an extra 3 inches of air clearance under the radiator from the front so they'll share the front's intake. Plus the AIO looks better with just a gap on the bottom instead of a gap on both the top and bottom. Of coarse nothing is that simple. I can't get all 8 holes clear by sliding it up that high instead of where it's suppose to go. The 4 middle inner screw holes are blocked now.
Will 4 screws mounted on all 4 outside corners be enough to secure it? I mean hell I only got one screw in so far in 1 corner and it's fairly snug. Each fan I'm mounting to the case will have 2 screws so they won't be able to rotate around plus they are sandwiched between themselves, the case, and the radiator. I think it'll be fine but I wanted to hear from some people who know what they're doing. This is my first PC build.
Thanks
Will 4 screws mounted on all 4 outside corners be enough to secure it? I mean hell I only got one screw in so far in 1 corner and it's fairly snug. Each fan I'm mounting to the case will have 2 screws so they won't be able to rotate around plus they are sandwiched between themselves, the case, and the radiator. I think it'll be fine but I wanted to hear from some people who know what they're doing. This is my first PC build.
Thanks