Msi 970a sli Krait edition will not post or move into bios.

[Cendosmansabe]

Computer will not post or boot at all, it flashes a series of 92, 9c at the bottom right corner and stays black. The current build is:
Amd a3+ fx-8320 3.5 GHz 8-core black edition
Msi 970a sli krait edition mother board
Antec 550w vp550f continuous 550 w power
Nvidia evga gtx 750 ti 2gb ddr5 gpu
Msi commander snow tower case
Corsair vengeance 4 gb ddr3 1600hz
Patriot 4gb ddr3 1600 hz
Pacific sun 4gb ddr3 1600 hz
Wd blue 1tb hdd
Wd black 1tb hdd
Asus 24x disc reader/burner.
I've been battling and swapping parts a good chunk of the weekend and have no clue what to do, I can't even get to the BIOS.

I've tried everything I could think of, and am at my wits end v abdicate just really want my comp up and running again, thank you guys for your time

 

[Alex Dorades]

Try access BIOS and load defaults. You have to flush BIOS or updated it.

 

[Cendosmansabe]

I've tried resetting to defaults, but after the 92, 9c flash on that bottom corner the screen goes black and it doesnt load any further, I haven't been able to get into the BIOS at all to flash it and update it.

 

[Alex Dorades]

You need clean your boot. Because its sticks to old devices or devices with different "profiles". Or just upgrades.

1. Shutdown your pc
2. Switch off the power supply from the back
3. Remove power cable from the power supply
4. Open your case and remove the RAMs
5. Put the power supply cable back in
6. Switch on power supply
7. Wait for 10 minutes with out RAMs. DONT TURN ON THE PC, Only let it on power for 10 minutes.
8. After 10 min switch power supply off
9. Open case and put the RAMs again into the motherboard (slot 1,3 or 2,4)
10. Switch on the power supply and turn the pc on.

This is a procedure that we technicians do to clean "old profiles". This happens if you install a new component and you didn't uninstalled previous drivers and stuck at black screen.
You can also renew boot manager but this is a different method.

 

[Cendosmansabe]

The profile wipe left me with the same results, is there any other options? Every part is brand new except for the Wd blue 1tb which was my hard drive for the last build.