MSI B450M mobo LED switch on during startup

[May2ko]

I have my motherboard LED lights to be switched off through the MysticLight app but during startup the lights switch on and won’t switch off until fully loaded into Windows which is when I assume the MysticLight relaunches and then remembers that the LED should be switched off

Motherboard is MSI B450M Mortar

Any help or ideas appreciated

 

[theRTT]

I don't really see the problem if they do turn off when it's booted up completely. I mean, they turn of how you want them to right?
I have the same thing going on with NZXT's CAM software, where I control my led lighting with. When I start up my pc, the led strips only display the right color when the CAM software is started up. So I assume it's working just fine.

For as far as I can see, there is no option to turn it off in your bios.

Maybe try this, if you already haven't: Advanced/Power Management Setup/On board LED Control ==> Off

 

[May2ko]

I don't really see the problem if they do turn off when it's booted up completely. I mean, they turn of how you want them to right?
I have the same thing going on with NZXT's CAM software, where I control my led lighting with. When I start up my pc, the led strips only display the right color when the CAM software is started up. So I assume it's working just fine.

For as far as I can see, there is no option to turn it off in your bios.

Maybe try this, if you already haven't: Advanced/Power Management Setup/On board LED Control ==> Off

I found a solution. In the MysticLight app, instead of setting the LED state to off, I set the it to steady and changed the LED colour to black. Since the LED cannot literally output the colour black, it just switches off and stays switched off even during boot.

 

[theRTT]

I don't really see the problem if they do turn off when it's booted up completely. I mean, they turn of how you want them to right?
I have the same thing going on with NZXT's CAM software, where I control my led lighting with. When I start up my pc, the led strips only display the right color when the CAM software is started up. So I assume it's working just fine.

For as far as I can see, there is no option to turn it off in your bios.

Maybe try this, if you already haven't: Advanced/Power Management Setup/On board LED Control ==> Off

I found a solution. In the MysticLight app, instead of setting the LED state to off, I set the it to steady and changed the LED colour to black. Since the LED cannot literally output the colour black, it just switches off and stays switched off even during boot.

Good to know you found a solution. I assume you don't want to see any leds at all?

 

[May2ko]

I don't really see the problem if they do turn off when it's booted up completely. I mean, they turn of how you want them to right?
I have the same thing going on with NZXT's CAM software, where I control my led lighting with. When I start up my pc, the led strips only display the right color when the CAM software is started up. So I assume it's working just fine.

For as far as I can see, there is no option to turn it off in your bios.

Maybe try this, if you already haven't: Advanced/Power Management Setup/On board LED Control ==> Off

I found a solution. In the MysticLight app, instead of setting the LED state to off, I set the it to steady and changed the LED colour to black. Since the LED cannot literally output the colour black, it just switches off and stays switched off even during boot.

Good to know you found a solution. I assume you don't want to see any leds at all?

Yeah, it's just that it was a bit annoying that it would light up during boot and shut down for no reason even though I had LED switched off.

 

[theRTT]

Ah okay, that makes sense than. Nicely done.