Is new build or just refilled?
Graphics card is new, everything else is about six months old. Had a 2080 ti gaming x trio waterblocked prior and worked perfectly. I’m hoping I plugged the power cables in right. The 2080 ti has 2 8pin and 1 six pin connector, which was conveniently connected already when the pc was bought. Since the 3090 has 3 8 pins, I plugged the cables in as they were positioned in the 2080 ti in the 3090, and managed to also find a separate 2 pin connector hiding behind my psu but also connected with the 6 pin. Was I correct to plug this 2 pin with the 6 pin into the 3090? Also all the rgb lights come on in the 3090 as well. I’ve read it could be a bios update or needing to install drivers for my 3090 but I wanted to see here first to double check before going through the process of uninstalling and reinstalling graphics cards cause it’s a bit of a hassle with liquid cooling
EDIT: I’ve tried powering on my pc with all three monitors plugged into gpu, and none have turns one, and I have tried one monitor plugged into all three different ports. When I unplug the monitor it shows no signal, and when I go to plug it in via DP the message disappears for a few seconds like it’s trying to register a signal, only to show up with no signal detected again. So I’m not sure where to start. All these cables and monitors worked with my 2080 ti.
EDIT EDIT: I forgot the original intent of this post which was with the air bubble. After fully powering it off and giving it a good flip and rotation, the pocket seems to have gone away. Only experiencing this no signal detection issue now which ruined my vibe :/