MSI R9 280 problem

[Kalmado]

Hardware:

cpu: fx 6300
mb: Gigabyte GA-78LMT-USB3 v 5
ram: pny 8gb 1600
psu: xfx 550w 80+bronze
gpu: msi r9 280

I can't get any display after installing the gpu. Can load without just fine. In bios, set to PEG. In device manager, disabled on board. Nothing has worked. Card does power up, fans spin, etc.

Took msi card out and installed a VisionTek 7950. Worked fine. Trying to reset cmos and I'll uninstall CCC. Any suggestions on how to fix this?

 

[Coolboy951]

Go to bios and switch UFEI mode to LEGACY mode and than put the card in

 

[Kalmado]

Go to bios and switch UFEI mode to LEGACY mode and than put the card in

This motherboard uses Award Bios so I cannot perform that action. http://www.gigabyte.us/products/product-page.aspx?pid=4602#sp

After resetting cmos I ran display driver uninstall. Rebooted, set display to PEG, and now thing again. No idea what to do....

 

[Coolboy951]

Can you find secure boot in the bios?

 

[Kalmado]

Can you find secure boot in the bios?

I do not see secure boot anywhere in bios.

Tried reinstalling gpu again, and now onboard doesn't work either. Once I unplug gpu, onboard works again.

 

[Coolboy951]

okay put the old card in download the latest drivers with the 7950 and after that shut down the pc after the drivers are done and take the 7950 out and put the 280 in and connect every connection to it and than turn on the pc and let it turn on and wait 5-10 mins

 

[Kalmado]

So far still no display. Just so we're on the same page there is no display from the second the pc boots. Cannot see bios. Pc is running.

 

[Coolboy951]

have you updated your bios?

 

[Kalmado]

When checking bios it states the version is from 4/23/12. That is the only version on Gigabyte's page. http://www.gigabyte.com/products/product-page.aspx?pid=4602#bios

Is there somewhere else for a more updated bios?

 

[Coolboy951]

this may be a faulty card you have try getting a replacement

 

[Kalmado]

Thank you for trying so much to help. I've left a post on MSI's site as well. Hopefully it can get worked out.

 

[Coolboy951]

I hope this problem gets solved