Question Connecting multiple temperature sensors ?

[Magniphacent]

I am creating a new build and plan to have dual water loops. I am hoping to use in-line temperature sensor fittings at the pump output and the intake to the radiator on both loops to verify water temps. This means that I will have FOUR sensors to connect to my system, but my motherboard (ROG Crossfire VIII Formula) only has one two-pin temp connector.

Is there an interface box or some sort of mux unit that I can get to connect the sensors to and then have the data sent to the CPU for display using AIDA64? This will probably use the SATA or USB connections.

Thanks for any help that you can give.

 

[Lutfij]

Welcome to the forums, newcomer!

This means that I will have FOUR sensors to connect to my system, but my motherboard (ROG Crossfire VIII Formula) only has one two-pin temp connector.
You'd need something like this;
https://shop.aquacomputer.de/Monito...ontroller-for-PWM-fans::3832.html?language=en
Here's a manual URL if you want to learn more;
https://aquacomputer.de/handbuecher...uacomputer/downloads/manuals/OCTO_english.pdf

Moved thread from Motherboards section to Cooling section.

 

[Magniphacent]

Thak you, Lutfij, for the info and for moving the thread to the correct location.

I have seen this controller during my research, but did not need another fan controller (there are already two pre-installed in the case). But, looking at it cloaser, it is very small and should be able to get hiden pretty easily. The software looks like a possible replacement for AIDA64 as well.

I will look into this a little closer tomorrow, when I am not so tired.

Thaks, again, for the fast response!