Need help with bitfenix spectre pro LED!!

[valletitov]

Im thinking about buying a bitfenix spectre pro 140 mm led fan. If you dont plug the fan Led cable to a separate connection the brightness will go down when you´re decreasing the voltage to lower the fans rpm. I want the LEDs to always be at their brightest but I dont understand where to connect the LED cable
My motherboard: Gigabyte GA Z87 UD3H

 

[Karsten75]

Im thinking about buying a bitfenix spectre pro 140 mm led fan. If you dont plug the fan Led cable to a separate connection the brightness will go down when you´re decreasing the voltage to lower the fans rpm. I want the LEDs to always be at their brightest but I dont understand where to connect the LED cable
My motherboard: Gigabyte GA Z87 UD3H

Did you happen to visit the Bitfenix support page for your product and noticed the FAQ?



Frequently Asked Questions

Q: How do I connect my Spectre LED/Spectre Pro LED/Spectre Pro PWM LED cables?
There are two cables attached to the fan.
1) There is a 3 pin or 4 pin cable that will connect to your corresponding power source (molex, motherboard, fan controller). This will provide power to the fan blades and to the LED
2) The 2 pin cable has an attached cable loop. This cable is to turn on/off your LED's at your convenience. Do not plug it into a power source as there will be an electrical short and will burn your fan and cables. You can also attach this loop to our Hydra Pro fan controller for on-the-fly LED on/off.

 

[valletitov]

So the fan needs to run at full speed for the leds to be at their brightest?