Ive built a few systems before, but this one im getting no video
Im using an x11 MB with a xeon e3-1245 the x11 has ASPEED AST2400 BMC and the Xeon has Intel® HD Graphics P530. There are no expansion cards plugged in. The only things plugged in are the 20pin the CPU 8 pin, fans(including cpu fan) and 1 dimm. I have checked compatibility of the Ram, double checked stand offs to make sure one wasn't where it shouldn't be. When i power it on i get 1 beep. The manual says Error Message: Refresh, Circuits have been reset (ready to power up). I checked for bent pins on the MB and CPU. Right now its plugged into a monitor over DVI, but i also tried HDMI. Any Ideas thoughts?
Also read through and check these
http://www.tomshardware.com/forum/261145-31-perform-steps-posting-post-boot-video-problems
Im using an x11 MB with a xeon e3-1245 the x11 has ASPEED AST2400 BMC and the Xeon has Intel® HD Graphics P530. There are no expansion cards plugged in. The only things plugged in are the 20pin the CPU 8 pin, fans(including cpu fan) and 1 dimm. I have checked compatibility of the Ram, double checked stand offs to make sure one wasn't where it shouldn't be. When i power it on i get 1 beep. The manual says Error Message: Refresh, Circuits have been reset (ready to power up). I checked for bent pins on the MB and CPU. Right now its plugged into a monitor over DVI, but i also tried HDMI. Any Ideas thoughts?
Also read through and check these
http://www.tomshardware.com/forum/261145-31-perform-steps-posting-post-boot-video-problems
Facebook
Twitter
Instagram