The laptop was working well so I decided to pick up a new cpu for it. HP 6710b business edition. After some research I found the t9300 to be a good upgrade from my t7100. I bought a used chip. Before tearing it down I updated the bios from the HP website to F20. I installed the new CPU and it would not boot. It would turn on with a solid HDD light for 5 seconds then shut off. I reset the CMOS by holding the power button and removing the battery. After I did this the laptop will come on for 5 seconds as it did, shut off, then come back on by itself. I put back in the old CPU and it works fine. Any thoughts? Thanks
On a side note I noticed the CPU was missing a pin, but it looks like there was never one there just a little dot. I assume this is suppose to be like that.
On a side note I noticed the CPU was missing a pin, but it looks like there was never one there just a little dot. I assume this is suppose to be like that.
