Question New Ram Card Oc Help

[ProudPerson]

Hello guys
I just bought a new Memory card

Kingston FURY Renegade DDR4 Memory 2x16 3600 mhz
https://pasteboard.co/EDS6tyyHc8kW.jpg
https://pasteboard.co/iI69fURqoV2m.jpg

so what i did was to enter bios and open profile one
That is 3600mhz
And i add Dram up to 1.35V

and my pc enter bootloop

and after couple of boots the bios went default
And all i did was change mhz to 3500 and 1.35V
And pc boot up perfectly and no errors on memory check for 3 hours

any reason that i could not reach 3600mhz

ty very much

 

[drivinfast247]

Reset to default and then enable XMP

 

[ProudPerson]

Reset to default and then enable XMP

hey .. ty for the respond
I did.. but my pc wont allow me to boot when i go for 3600 mhz
So i went 3500 mhz and it works like a charm
But what i do like to know is the reason i get boot loop with this 100 mhz boost
Sanse my new card is 3600 mhz on his neture

 

[Zerk2012]

hey .. ty for the respond
I did.. but my pc wont allow me to boot when i go for 3600 mhz
So i went 3500 mhz and it works like a charm
But what i do like to know is the reason i get boot loop with this 100 mhz boost
Sanse my new card is 3600 mhz on his neture

Could be the CPU memory controller or the memory.
3600 is a overclock setting and not guaranteed to work without some adjustments.

 

[ProudPerson]

Could be the CPU memory controller or the memory.
3600 is a overclock setting and not guaranteed to work without some adjustments.

Ty for the respond
May i ask what kind of adjustments are needed please ?

 

[Zerk2012]

Ty for the respond
May i ask what kind of adjustments are needed please ?

Similar to just what you did got it stable at 3500, can try increasing the volts by 0.02 or loosen the timings.

 

[ProudPerson]

Similar to just what you did got it stable at 3500, can try increasing the volts by 0.02 or loosen the timings.

Well i did increase it to 1.4v
Got same result sadly
So i dont get where i went wrong tho