I just got my new ram and here it is:
http://www.newegg.com/Product/Product.aspx?Item=N82E16820104520
So I replace it with my old ones which were 2x4gb Corsair vengeance 1800mhz. Everything starts up fine, it says hardware has been changed... I go to setup to overclock as i follow the instructions here:
https://m.youtube.com/watch?v=w4sx-GuY3CA
Not 100% sure about my timings so I just put it on auto. Then I put my frequency to DDR3-2400 and my voltage to 1.65V. I then restart with all of my saved settings...
It turns on but no display and i don't see my GPU running. So then I restart and then it works and says, previous configurations could not be saved.
So I go back into bios and try every kind of voltage all the way down to 1.5V...