New Setup wont boot

[JackRogerz]

So i tried setting up my pc today and i bent 1 pin in the motherboard where it connects to the cpu. I used a sharp object and pushed it back its about 90% to the original. Ive seen people online bend like 5 or 6 and get them back like mine and it works fine. However my pc wont boot up at all. When i plug it in nothing happens at all no fans nothing. Do you think its a psu problem or should i replace the motherboard?

 

[Ironsounds]

Hello... You should be getting some led lights, there are many voltages from the PS to the MB, for different circuits... ARE these all New components you are using?

1) check your PS switch, power cord, and outlet.
2) Re-connect the MAIN power connector to your MB.
3) Remove the MB from the case, and test it on the MB Box.
4) Did you have any other problems with understanding where everything goes and plugging them in?

 

[JackRogerz]

Yes they are all brand new just out of the box, How would i test the mother board?

 

[strizlow800]

Sounds like something is not plugged in correctly. Check the little cables for power switches, system speaker, leds etc... Those little things know to cause BIG problems if not connected properly.