- Jul 17, 2014
- 33
- 0
- 18,530
Newbie Dave here, Do you guys normally install the I/O Shield 1st until it snaps in place and then the MB? I did it this way and the I/O ports seem to be recessed just a fraction of an inch.
I tested a USB drive just to see if it goes in and it seemed OK! All my MB screw holes lined up perfectly with the case and no problem with that.
Do you fit the I/O shield over the ports and put both in at same time? It just doesn't seem to look perfect!! Tks for any suggestions! DN
PS My MB is a ASRock FM2A88M Extreame 4+
My Case is a ThermalTake Core V41
I tested a USB drive just to see if it goes in and it seemed OK! All my MB screw holes lined up perfectly with the case and no problem with that.
Do you fit the I/O shield over the ports and put both in at same time? It just doesn't seem to look perfect!! Tks for any suggestions! DN
PS My MB is a ASRock FM2A88M Extreame 4+
My Case is a ThermalTake Core V41
Facebook
Twitter
Instagram