- Dec 14, 2024
- 4
- 0
- 10
Specs:
ASRock B650 PG Lightning
Ryzen 7600
7700 XT
2x T-Force Vulcan 16gb 6000MHz CL30
Corsair RM750x power supply
When using both ram sticks in the slots A2 and B2 - as the manual instructs - it tries to power on, gets the fans spinning a bit, turns on cpu and ram debug lights as it should when booting, then completely turns off for some reason. It then tries to boot again and the same thing occurs. It does this a couple of times before giving up and stops shutting down. It is then left with the two red debug lights lit, the cpu fan spinning alone as well as a screen that hasn't turned on yet. My question is basically, what do I do?
Some notes:
I cannot enter bios whilst two sticks are used.
I have tested each ram stick individually and they boot perfectly fine.
I have tested one of them in memtest86+ without errors, but couldn't get it to open while using both at the same time.
I have inspected the ram slots for debris and did not see anything.
I have not inspected the cpu for bent pins as I consider that a last resort. (I'm a first time builder and it was a little hard to figure out where the cooling stuff had to go)
Putting the sticks in A1 and B1 didn't work.
Using a single stick in A2 does not work (the manual recommends B2)
I have updated the bios to the most recent stable build (3.10)
I have tried turning on and off xmp and Expo as well as increasing the voltage to 1.4V, nothing made a difference.
I am aware that my sticks are not part of the memory QVL list of the motherboard, however I am fairly sure that the 5600Mhz version of them are in said list, so without knowing a whole lot about QVL stuff I assumed it would be fine. Please correct me if I'm wrong.
Any help would be greatly appreciated
ASRock B650 PG Lightning
Ryzen 7600
7700 XT
2x T-Force Vulcan 16gb 6000MHz CL30
Corsair RM750x power supply
When using both ram sticks in the slots A2 and B2 - as the manual instructs - it tries to power on, gets the fans spinning a bit, turns on cpu and ram debug lights as it should when booting, then completely turns off for some reason. It then tries to boot again and the same thing occurs. It does this a couple of times before giving up and stops shutting down. It is then left with the two red debug lights lit, the cpu fan spinning alone as well as a screen that hasn't turned on yet. My question is basically, what do I do?
Some notes:
I cannot enter bios whilst two sticks are used.
I have tested each ram stick individually and they boot perfectly fine.
I have tested one of them in memtest86+ without errors, but couldn't get it to open while using both at the same time.
I have inspected the ram slots for debris and did not see anything.
I have not inspected the cpu for bent pins as I consider that a last resort. (I'm a first time builder and it was a little hard to figure out where the cooling stuff had to go)
Putting the sticks in A1 and B1 didn't work.
Using a single stick in A2 does not work (the manual recommends B2)
I have updated the bios to the most recent stable build (3.10)
I have tried turning on and off xmp and Expo as well as increasing the voltage to 1.4V, nothing made a difference.
I am aware that my sticks are not part of the memory QVL list of the motherboard, however I am fairly sure that the 5600Mhz version of them are in said list, so without knowing a whole lot about QVL stuff I assumed it would be fine. Please correct me if I'm wrong.
Any help would be greatly appreciated
Facebook
Twitter
Instagram