"No Power cable connected to Video Card"

CynicalPatient

Distinguished
Dec 13, 2004
14
0
18,510
0
I have my computer system, it worked fine, and all I did was change the case. Now, at boot, it says "No power cable is connect to video card" when it is connected. I tried different wires and different modules/ports, but no luck. I even tried shorting the psu, still no work. Plz, someone help, namely Crashman??
 

Ned_Flanders

Splendid
Jan 30, 2004
7,502
0
30,780
0
Plz, someone help, namely Crashman??
This is becoming a joke.
I think I'll PM Fredi asking him to change the forum name to 'Noob Crashman Appreciation Society'

I'd help, but I don't want to.


__________________
<A HREF="http://www.moviewavs.com/MP3S/TV_Shows/Simpsons/flanderssong.mp3" target="_new">Audio Sig</A>|<A HREF="http://community.tomshardware.com/images/logo_black_xmas2.gif" target="_new">I made this!</A>
 

CynicalPatient

Distinguished
Dec 13, 2004
14
0
18,510
0
Wow, still no constrctive replies. Someone plz help? I havent been on my good comp since holidays started. And now they are half up, plz, any help???
 

Crashman

Polypheme
Dec 31, 2007
48,327
0
65,960
74
Did you change power supplies too? Make sure the cable going to the video card power isn't shared with other devices.

Normally a failed boot after changing cases is caused by a circuit on the back of the board being grounded by a misplaced standoff. But I'm not so certain of that given the message you're receiving. Still worth checking.

<font color=blue>Only a place as big as the internet could be home to a hero as big as Crashman!</font color=blue>
<font color=red>Only a place as big as the internet could be home to an ego as large as Crashman's!</font color=red>