Normal tenp for ga-78lmt-s2p?

[Aleksandar Mirkovic]

So what is normal temperature for this mobo(rev 5.x).
My HWmonitor is showing 37-41on idle and 40-46 on load which is more than all of my hardware,well just not GPU,GPU is a bit higher. My BIOS shows the same temp too. Right after the turn off when i tuch heatsinks on MOBO i get burns of 3rd degree. 😀
So is it normal?
Oh yeah,what's the normal temp temp for most of the boards?

 

[Dark Lord of Tech]

Are you using the FX8320 or 8350 ? , if you are it's normal as the board has a very poor power and thermal design.

Not a good fit for 8 cores.

 

[Aleksandar Mirkovic]

My bad,I forgot. Sorry :/
AMD FX 4130 stock cooler,clock and boost clock.
Hyperx blu 1x4gb 1600mhz
WDD green 500gb 7k rmp
600w sharkoon with 2x 30A on 12v

 

[manicd]

The heatsink you touched that is hot is the northbridge heatsink which has the 760g chipset under it. That chip is known to get hot and is rated for high temps. You can cool off with a fan or better case air flow. The northbridge 760g does not temp senor you can read with sofware. Your HWmonitor temps are fine. The only important one is the Package temp for the cpu. Keep that below 60c. I mean also watch the other temps now and then to make sure there are no other problems though.

 

[Aleksandar Mirkovic]

Thank you for your answer.
1 more thing that happened last night and i couldnt write it here.
I have lately alot of BSOD's lately after which my PC wont boot instantly.Screen goes black,and hardware goes in circles with restarting. After some time it starts and boots normaly. But last night before windows loading logo i got message "The system has expiriencedboot failuers because of overclocking" but on my system nothing is overclocked. Everything is on stock.
if it's of any help i get error message in event viewer:
Performance power management features on processor 3 in group 0 are disabled due to a firmware problem. Check with the computer manufacturer for updated firmware.
And that goes for processor 0,1 and 2 too.
Oh yea,BSOD code is always 0x0a with "irql not less or equal"