G
Guest
Guest
Hey guys. I'm going for the coolermaster 690 III with the following setup:
1 x Coolermaster Megaflow 200m for Top (red led, non pwm) (exhaust)
1 x Coolermaster Megaflow 200m for front (red led, non pwm)(intake)
1 x XIlence 120mm pwm fan for rear (exhaust)
1 x XIlence 120mm pwm fan for bottom (intake, as hot air rises? Not sure)
Coolermaster fan
Xilence fan
Using Asus Maximus VII Ranger mobo. Would it be okay to use this pwm splitter for my 2 120 PWM fans, and then this 3 pin fan spiltter for my 2 coolermaster fans (bear in mind they're led)?
Is this an okay setup or is there a better way to do it? I'm not too keen on fan controllers as the cabling can get cluttery and what not.
What would noise be like? Would the PWM fans still be able to be automatically adjusted by the mobo using the pwm fan splitter?
Thanks
1 x Coolermaster Megaflow 200m for Top (red led, non pwm) (exhaust)
1 x Coolermaster Megaflow 200m for front (red led, non pwm)(intake)
1 x XIlence 120mm pwm fan for rear (exhaust)
1 x XIlence 120mm pwm fan for bottom (intake, as hot air rises? Not sure)
Coolermaster fan
Xilence fan
Using Asus Maximus VII Ranger mobo. Would it be okay to use this pwm splitter for my 2 120 PWM fans, and then this 3 pin fan spiltter for my 2 coolermaster fans (bear in mind they're led)?
Is this an okay setup or is there a better way to do it? I'm not too keen on fan controllers as the cabling can get cluttery and what not.
What would noise be like? Would the PWM fans still be able to be automatically adjusted by the mobo using the pwm fan splitter?
Thanks