Question Overclock 8086k on Aorus Master Board / Results and questions

[Asryan]

Hello I finally managed to pass an OCCT without error

1 hour test, large files, avx 2
8086k processor
Aorus Master Z390
vcore 1.325
Turbo LLC

Are these results ok?

https://www.casimages.com/i/200506040727255581.jpg.html

Also I wanted to know :

if I should set up an adaptive profile and what is the way to go

Should I disable c state and speedshift or leave it enabled?


Thanks

For the full settings :

MANUAL PROFILE

ADVANCED FREQUENCY SETTINGS


CPU Base clock 100
CPU upgrade : auto
Enhanced multi core performance : disabled
CPUclock ratio 50
FCLK frequency for early power on : 1Ghz
XMP : profile 1
Vt-d disabled



Advanced cpu core settings
AVX offset : 0
Uncore ratio : auto
Intel turbo boost technology : on
Cores : 50 all cores
C state : disabled
SpeedShift : disabled



ADVANCED VOLTAGE SETTINGS

Advanced power settings
CPU internal AC/ DC Load Lines : auto
CPU VCORELoadline calibration turbo
CPU vcore current protection : auto



CPU core voltage control
Manual
CPU vcore : 1.325C
VCCIO 1.15
CPU SA : 1.15
CPU current limit 255
Power maxed out

Cpu vcore PWM switch rate : 300

 

[Asryan]

Hi,
I just tried to set up an adaptive vcrore on my Aorus Master board / 8086K
My stable vcore for 5ghz was 1.325, so:
i put vcore on auto, saw it was putting 1.380 on load so i put an offset of 1.380-1.325 = 0.050
Also i activated cstate, speedshift and put IA DC at 1

LLC is on turbo
I did a cinebench and got those :
https://www.casimages.com/i/200507084007697637.png.html
On desktop vcore is going from 0.363 to 1.260 without load.
Am i missing something to set it all on adaptive or is it all good?
Thanks