overclocking bsod issue

[Haitham mohamed]

hello there when I overclock my pc it gave me this bsod my cpu is i7 4790k / 16 gb gskill ram /sandisk ssd 240 gb / msi sli plus Mb when I push my cpu from 4 ghz to 4.8 ghz it is appear when using 3dsmax rendering only intel burn test is ok I reduced th ring ratio many times but still same error
plez help me

http://

 

[Aladdad]

What Voltages? try increasing the voltages... you need to find the best combination of voltages and clock speeds... not all cpus overclock the same so you can't rely on someones results...even if they had the exact same system as yours.. make sure your temps are fine as well. BSOD is basically a unstable overclock which is nothing to worry about just keep trying untill you find stability... that is overclocking for you.. BSODs over and over..

 

[Haitham mohamed]

What Voltages? try increasing the voltages... you need to find the best combination of voltages and clock speeds... not all cpus overclock the same so you can't rely on someones results...even if they had the exact same system as yours.. make sure your temps are fine as well. BSOD is basically a unstable overclock which is nothing to worry about just keep trying untill you find stability... that is overclocking for you.. BSODs over and over..

THANKS MAN @4.8 ghz the voltage was 1.375v in (automatic mode) I had increased to 1.45v but still unstable I will try 1.5 v the heat between 85 - 90 c I noticed that that the cpu speed decreased when it reach 100 c but the system stable but not stable with 3dsmax thanks again

 

[Aladdad]

What Voltages? try increasing the voltages... you need to find the best combination of voltages and clock speeds... not all cpus overclock the same so you can't rely on someones results...even if they had the exact same system as yours.. make sure your temps are fine as well. BSOD is basically a unstable overclock which is nothing to worry about just keep trying untill you find stability... that is overclocking for you.. BSODs over and over..

THANKS MAN @4.8 ghz the voltage was 1.375v in (automatic mode) I had increased to 1.45v but still unstable I will try 1.5 v the heat between 85 - 90 c I noticed that that the cpu speed decreased when it reach 100 c but the system stable but not stable with 3dsmax thanks again

Uhhh, i would recommend not going over 1.45v or even 1.4v just because it will lower your CPUs life significantly. It is recommended that you stay under 1.4v try for 4.6 at 1.25v and keep pushing your voltages if it crashes.. if not try lowering it or increase multiplier... also 85c is too hot.. what cooler are you using? if you are using the stock cooler.. that would explain all the bsods because its over heating.

 

[Haitham mohamed]

thanks again aladdad iam using cooler master evo 612 it will be upgraded to noctua d15 any way I will not increase the ratio more than 4.7 ghz until I fix the heat of the cpu about the volt I think I will fix it to 1.3v @4.7 ghz