[SOLVED] overclocking Intel E6600 3.06GHZ

[Ranzellagdeppa]

I OC my Intel E6600 3.06ghz,1.27500volts to 3.41ghz, 1.32500volts.I just need help with oc further more
my specs(low end):
ga_g41mt-s2(rev1.5)
2x4 ddr3 ram (different brands)
geforce gt220

 

[4745454b]

What settings are you using to get to 3.41? What speed is the ram running at? What are they rated for?

If you have DDR3-800MHz ram, the best thing to do is set the FSB to 400, run the ram 1:1, and set the CPU multiplier as high as you can get. If I've done the math right your E6600 runs a 266FSB with a multiplier of 11.5. If you set the FSB to 400MHz and the multiplier to 9, you should be running at 3.6GHz. You might be able to get a bit more, but that low end G41 board is going to hold you back.

 

[Ranzellagdeppa]

I'm using 11.0+0.5 multiplier with 297 host frequentcy(11.5x297).The ram is running 500mhz to 600mhz I'm using a different brands of ram,I think the system will not going to be stable.What rated?Volts, if volts its at 1.5 volts

 

[4745454b]

Your ram should be rated at DDR2-800,or other such numbers. There should be timings as well. If you have DDR2-800 what I posted above should work. If your ram isn't, you'll need to find other settings. But we can't suggest until we know what you have.

 

[Ranzellagdeppa]

frequency:594 mhz
fsb:1:2
cl:9 clocks
trcd:9 clocks
trp:9 clocks
tras:22 clocks
trfc:96 clocks
cr:2t

i use cpuz to see info

 

[4745454b]

That would be what's its running at. Not what they are rated for.

Try my idea of running at 400MHz. Might work.

 

[Ranzellagdeppa]

I think what's your trying to say

ddr3-1184 and DRAM Frequency in Cpu-Z is 594.

More ram info in cpu-z:

Memory Frequency 594.1 MHz (1:2)
CAS# latency (CL) 9.0
RAS# to CAS# delay (tRCD) 9
RAS# Precharge (tRP) 9
Cycle Time (tRAS) 22
Row Refresh Cycle Time (tRFC) 96
Command Rate (CR) 2T
Host Bridge 0x2E30


DIMM #1
SMBus address 0x50
Memory type DDR3
Module format UDIMM
Module Manufacturer(ID) Samsung (CE00000000000000000000000000)
Size 2048 MBytes
Max bandwidth PC3-10700 (667 MHz)

DIMM #2
SMBus address 0x52
Memory type DDR3
Module format UDIMM
Module Manufacturer(ID) Crucial Technology (7F7F7F7F7F9B0000000000000000)
Size 2048 MBytes
Max bandwidth PC3-10700H (667 MHz)

 

[4745454b]

Again, that's what they are running at. What are they rated for? No where in this thread have you said what ACTUAL ram sticks you have. I know they are different sticks, but without know what they are rated to run at we can't tell you what settings to use.

If you are running ~300MHz FSB, what is the CPU multiplier set at?