[SOLVED] Page fault in non paged area

[Astro sco]

Keep getting a Page fault in non paged area bsod every once in a while one of the ram sticks were fault but still happens and tried a new ssd only thing not checked is my internal hard drive and the only thing I can think after that is mabye the cpu need ways of checking the hard drive and cpu if possible

 

[JohnBonhamsGhost]

Keep getting a Page fault in non paged area bsod

try just setting a custom Page File in another location.
Settings > System > About > Advanced system settings(on the right)

 

[Astro sco]

Anymore or is it easy to find from here will try this tommorow thanks

 

[JohnBonhamsGhost]

Anymore or is it easy to find from here

have no clue what this is supposed to mean

 

[mamasan2000]

Non-paged area is common to see when RAM is unstable.

 

[Astro sco]

have no clue what this is supposed to mean

U said how to get into something like will it be in my face when I follow your directions or is there more to get to it and change the page thing

 

[Astro sco]

Non-paged area is common to see when RAM is unstable.

Done a mem test on both my sticks 1 had too many errors it had to abort the test the other was fine but even the one with no errors it happens

 

[SkyNetRising]

Done a mem test on both my sticks 1 had too many errors it had to abort the test the other was fine but even the one with no errors it happens

Full specs of your system?
Is ram overclocked?

Could be overclocked too aggressively. Tune down your overclock.

 

[Astro sco]

Full specs of your system?
Is ram overclocked?

Could be overclocked too aggressively. Tune down your overclock.

B450-m plus 2
Ryzen 5 3500
2x corrsair vengeance lpx 8gb (one obvs fault and not in my system now)
1060 3gb

nothing is over locked etc

 

[SkyNetRising]

Can you show screenshot from CPU-Z - memory and spd sections?
(upload to imgur.com and post link)

 

[Astro sco]

Can you show screenshot from CPU-Z - memory and spd sections?
(upload to imgur.com and post link)

https://imgur.com/a/PCIHESU

View: https://imgur.com/a/PCIHESU

 

[SkyNetRising]

Go into BIOS and set ram parameters:
DDR voltage 1.35V
Latencies 16-20-20-38
Command rate 1T
Set frequency to 2133mhz, test stability.
If stability is good, then increase frequency and test again (2400,2666,2800,2933,3000mhz).
When test fails, then go back to previous stable settings.